ATS Racing Turn key 550 whp build up
| LABOR | ||||||
| HOURS | SERVICE PERSON | DESCRIPTION | RATE PER HOUR | TOTAL | ||
| 23.00 | ATS | r&r motors | 75.00 | 1,725.00 | ||
| 3.00 | ATS | assemble long block | 75.00 | 225.00 | ||
| 10.00 | ATS | tuning AEM | 75.00 | 750.00 | ||
| 0.50 | ATS | throttle cable bracket | 75.00 | 37.50 | ||
| 1.50 | ATS | race gas tuning | 75.00 | 112.50 | ||
| 6.40 | ATS | install dual fuel pumps | 75.00 | 480.00 | ||
| 1.30 | ATS | install CV's in axles | 75.00 | 97.50 | ||
| 2.00 | ATS | install gauges | 75.00 | 150.00 | ||
| 9.00 | ATS | install WTA IC, incl heat exchanger | 75.00 | 675.00 | ||
| 2.00 | ATS | degree cams on dyno | 75.00 | 150.00 | ||
| Labor subtotal | 4,402.50 | |||||
| PARTS | Total labor cost | 4,402.50 | ||||
| ITEM | DESCRIPTION | QTY | UNIT COST | |||
| RMR 70mm manifold | 1 | 695.00 | 695.00 | |||
| 65mm throttle body with MR2 throttle cam | 1 | 209.00 | 209.00 | |||
| AEM Standalone | 1 | 1625.00 | 1625.00 | |||
| AEM wideband | 1 | 319.00 | 319.00 | |||
| AEM serial gauge | 1 | 279.00 | 279.00 | |||
| dual gauge pod | 1 | 39.00 | 39.00 | |||
| Greddy Profec B | 1 | 319.00 | 319.00 | |||
| ATS 2.2l Stroker short block | 1 | 2200.00 | 2200.00 | |||
| HKS 264 cams | 2 | 340.00 | 680.00 | |||
| ATS adjustable cam gears | 1 | 150.00 | 150.00 | |||
| 3 angle valve job | 1 | 450.00 | 450.00 | |||
| replace exhaust guides | 8 | 8.00 | 64.00 | |||
| Ferrea Valves | 16 | 19.50 | 312.00 | |||
| Cut seats for larger valves | 16 | 8.00 | 128.00 | |||
| ATS valve springs | 1 | 96.00 | 96.00 | |||
| oil pump, high volume | 1 | 169.00 | 169.00 | |||
| TTE head gasket | 1 | 160.00 | 160.00 | |||
| Toyota gasket kit | 1 | 209.00 | 209.00 | |||
| Wolfkatz rail | 1 | 325.00 | 325.00 | |||
| Walbro Fuel pump | 2 | 129.00 | 258.00 | |||
| 1150cc injectors | 4 | 130.00 | 520.00 | |||
| fuel line kit with fittings | 2 | 149.00 | 298.00 | |||
| L19 head studs | 1 | 350.00 | 350.00 | |||
| idle air control motor | 1 | 99.99 | 99.99 | |||
| TPS connectors | 2 | 14.99 | 29.98 | |||
| MAP sensor 3.5 bar | 1 | 158.99 | 158.99 | |||
| vacuum fitting for RMR | 8 | 1.99 | 15.92 | |||
| catch can | 1 | 99.99 | 99.99 | |||
| ait sensor | 1 | 39.99 | 39.99 | |||
| ATS 4" intake | 1 | 150.00 | 150.00 | |||
| ATS CV joints | 1 | 299.00 | 299.00 | |||
| 5 gallons 110 fuel (for tuning) | 5 | 6.00 | 30.00 | |||
| axle seal | 2 | 17.99 | 35.98 | |||
| CM stage 4 clutch | 1 | 499.00 | 499.00 | |||
| flywheel - lightweight | 1 | 369.00 | 369.00 | |||
| flywheel bolts | 8 | 6.79 | 54.32 | |||
| ATS GT3582 turbocharger kit | 1 | 2700.00 | 2700.00 | |||
| WTA intercooler core | 1 | 499.00 | 499.00 | |||
| blow off valve (typical) | 1 | 199.00 | 199.00 | |||
| Intercooler charge pipe set | 1 | 300.00 | 300.00 | |||
| front mount heat exchanger | 1 | 249.00 | 249.00 | |||
| intercooler water line and fitting kit | 1 | 219.00 | 219.00 | |||
| intercooler water pump | 1 | 187.00 | 187.00 | |||
| intercooler reservoir | 1 | 119.00 | 119.00 | |||
| antifreeze | 3 | 14.99 | 44.97 | |||
| oil 10w-30 | 4 | 1.99 | 7.96 | |||
| oil filter - Toyota | 1 | 7.99 | 7.99 | |||
| Transmission refill kit | 1 | 59.00 | 59.00 | |||
| Berk Technology 3" exhaust | 1 | 699.00 | 699.00 | |||
| Parts subtotal | 17,027.08 | |||||
| Tax rate | 8.5 | % Tax | 1,447.30 | |||
| Shop Items | 125.00 | |||||
| Payments | ||||||
| Total | 23,001.88 | |||||
We have made over 575 whp with this setup at ~27 psi (750 flywheel hp) on Aaron's 2.2 MR2
If you are shipping the vehicle to/from outside of Texas the sales tax can be removed. We can provide a shipping service anywhere in the US for approximately the same cost as the TX sales tax.
This quote assumes a good condition MR2, with acceptable core parts (block, head, etc) and a good to excellent condition transmission. If you have any doubts about the condition of your transmission we recommend purchasing a new LSD transmission (available below). Also we can offer rebuilt 91-92 style transmissions or rebuild your transmission and install a more aggressive aftermarket LSD if you prefer. Other options exist such as ceramic coatings, engine dress up parts, short shifters and complete suspension upgrades.
Timeframe: unless special arrangements are made, expect your build to take between 3 and 4 months depending on product availability.
Optional: NEW OEM LSD Transmission with LSD adapter kit MR2 ONLY $2080